NMFS Reallocates Pacific Cod from Vessels Using Jig Gear and Catcher Vessels Greater Than or Equal to 60 Feet Length Overall Using Hook-And-Line Gear to Catcher Vessels Less Than 60 Feet Length Overall Using Hook-And-Line or Pot Gear in the Bering Sea and

August 22, 2018 - 3:00 p.m.

Notice of a fishery management action.

Sustainable Fisheries

The National Marine Fisheries Service (NMFS) is reallocating 900 metric tons (mt) of Pacific cod from vessels using jig gear and 363 mt from catcher vessels greater than or equal to 60 feet length overall (LOA) using hook-and-line gear to catcher vessels less than 60 feet LOA using hook-and-line or pot gear in the Bering Sea and Aleutian Islands management area, according to James W. Balsiger, Administrator, Alaska Region, NMFS.

The following table summarizes the reallocation in metric tons:

Pacific CodCurrent ShareThis ActionRevised Share
Jig Gear 1,149-900249
Catcher Vessels >= 60 ft LOA using hook-and-line gear 363-3630
Catcher Vessels 5,027+1,2636,290

This action is necessary to allow the 2018 total allowable catch of Pacific cod to be harvested and is issued pursuant to 50 CFR 679.20(a)(7)(iv)(C). This action does not imply any change in the status of the fisheries.

This information bulletin only provides notice of a fishery management action. For the purposes of complying with the requirements of this action, you are advised to see the actual text of the action in the Federal Register.

Last updated by Alaska Regional Office on February 11, 2019