2016 Oregon Department of Geology and Mineral Industries (DOGAMI) Oregon Lidar DEM: McKenzie River

Quantum Spatial collected Light Detection and Ranging (LiDAR) data for the Oregon LiDAR Consortium (OLC) McKenzie River study area. This study area is located near Eugene, Oregon. The collection of high resolution geographic data is part of an ongoing pursuit to amass a library of information accessible to government agencies as well as the general public.

In May and June 2016 QSI employed remote-sensing lasers in order to obtain a total area flown of 141,508 acres. Settings for LiDAR data capture produced an average resolution of at least eight pulses per square meter. The LiDAR survey occurred between May 28 and June 21 of 2016, utilizing a Leica ALS80 mounted in a Cessna Grand Caravan. The systems were programmed to emit single pulses at around 189 kHz and flown at 1,500 m AGL, capturing a scan angle of 15 degrees from nadir. These settings were developed to yield points with an average native density of greater than eight pulses per square meter over terrestrial surfaces.

Final products created include 6-inch orthophotos, RGB extracted (from NAIP imagery) LiDAR point cloud data, three foot digital elevation models of highest hit and bare earth ground models, 1.5 foot intensity rasters, 1.5 foot ground density, study area vector shapes, and corresponding statistical data. Final deliverables were projected in Oregon Statewide Lambert Conformal Conic. This metadata was created for the bare earth digital elevation models.

Original contact information:

Contact Name: Jacob Edwards

Contact Org: DOGAMI

Phone: 971-673-1557

Email: jacob.edwards@oregon.gov

Provide high resolution terrain elevation data.

12127

A final report for this project may be viewed at:

https://noaa-nos-coastal-lidar-pds.s3.amazonaws.com/laz/geoid18/6317/supplemental/2016_McKenzie_Final_Data_Report.pdf

Any conclusions drawn from the analysis of this information are not the responsibility of the Oregon Department of Geology and Mineral Industries (DOGAMI), the Office for Coastal Management or its partners.

This data can be obtained on-line at the following URL: https://coast.noaa.gov/dataviewer

;

None

Users should be aware that temporal changes may have occurred since this data set was collected and some parts of this data may no

longer represent actual surface conditions. Users should not use this data for critical applications without a full awareness of its

limitations.

unknown

Vertical Accuracy reporting is designed to meet guidelines presented in the National Standard for Spatial Data Accuracy (NSSDA) (FGDC, 1998) and the ASPRS Guidelines for Vertical Accuracy Reporting for LiDAR Data V1.0 (ASPRS, 2014). The statistical model compares known ground survey points (GSPs) to the closest laser point. Vertical accuracy statistical analysis uses ground survey points in open areas where the LiDAR system has a "very high probability" that the sensor will measure the ground surface and is evaluated at the 95th percentile.

For the OLC McKenzie River study area, a total of 1,723 GSPs were collected. An additional 56 reserved ground survey points were collected for independent verification, resulting in a non-vegetated vertical accuracy (NVA) of 0.054 meters.

For more information about the vertical accuracy, please refer to the final report, listed above in the Supplemental_Information field

of this metadata record.

; Quantitative Value: 0.054 meters, Test that produced the value: Tested to meet FVA at a 95 percent confidence level in meters.

LiDAR data has been collected and processed for all areas within the project study area.

Upon receipt from vendor (Quantum Spatial), all LiDAR data was independently reviewed by staff from the Oregon Department of Geology and Mineral Industries (DOGAMI) to ensure project specifications were met. All data were inventoried for completeness and data were checked for quality, which included examining LiDAR data for errors associated with internal data consistency, model quality, and accuracy.