Data Management Plan
DMP Template v2.0.1 (2015-01-01)Please provide the following information, and submit to the NOAA DM Plan Repository.
Reference to Master DM Plan (if applicable)
As stated in Section IV, Requirement 1.3, DM Plans may be hierarchical. If this DM Plan inherits provisions from a higher-level DM Plan already submitted to the Repository, then this more-specific Plan only needs to provide information that differs from what was provided in the Master DM Plan.
1. General Description of Data to be Managed
Habitat maps of the main Hawaiian Islands were created by visual interpretation of aerial photos and hyperspectral imagery using the Habitat Digitizer extension. Aerial photographs are valuable tools for natural resource managers and researchers since they provide an excellent record of the location and extent of habitats. However, spatial distortions in aerial photographs due to such factors as camera angle, lens characteristics, and relief displacement must be accounted for during analysis to prevent incorrect measurements of area, distance, and other spatial parameters. These distortions of scale within an image can be removed through orthorectification. During orthorectification, digital scans of aerial photos are subjected to algorithms that eliminate each source of spatial distortion. The result is a georeferenced digital mosaic of several photographs with uniform scale throughout the mosaic. Features near land are generally georeferenced with greater accuracy while the accuracy of features away from land is generally not as good. Where no land is in the original photographic frame only kinematic GPS locations and image tie points were used to georeference the images. After an orthorectified mosaic is created, photointerpreters can accurately and reliably delineate boundaries of features in the imagery as they appear on the computer monitor using a software interface such as the Habitat Digitizer.
Notes: Only a maximum of 4000 characters will be included.
Notes: Data collection is considered ongoing if a time frame of type "Continuous" exists.
Notes: All time frames from all extent groups are included.
Notes: All geographic areas from all extent groups are included.
(e.g., digital numeric data, imagery, photographs, video, audio, database, tabular data, etc.)
(e.g., satellite, airplane, unmanned aerial system, radar, weather station, moored buoy, research vessel, autonomous underwater vehicle, animal tagging, manual surveys, enforcement activities, numerical model, etc.)
2. Point of Contact for this Data Management Plan (author or maintainer)
Notes: The name of the Person of the most recent Support Role of type "Metadata Contact" is used. The support role must be in effect.
Notes: The name of the Organization of the most recent Support Role of type "Metadata Contact" is used. This field is required if applicable.
3. Responsible Party for Data Management
Program Managers, or their designee, shall be responsible for assuring the proper management of the data produced by their Program. Please indicate the responsible party below.
Notes: The name of the Person of the most recent Support Role of type "Data Steward" is used. The support role must be in effect.
Programs must identify resources within their own budget for managing the data they produce.
5. Data Lineage and Quality
NOAA has issued Information Quality Guidelines for ensuring and maximizing the quality, objectivity, utility, and integrity of information which it disseminates.
(describe or provide URL of description):
- 2002-01-01 00:00:00 - Aerial photographs were acquired for the main Hawaiian Islands Benthic Mapping Project in 2000 by NOAA Aircraft Operation Centers aircraft and National Geodetic Survey cameras and personnel. Approximately 1,449, color 9x9 inch photos were taken of the coastal waters of the main Hawaiian Islands at a 1:24,000 scale. Prints and diapositives were created from the original negatives. Diapositivies were then scanned at a resolution of 500 dpi using a photogrammetric quality scanner, yielding one by one meter pixels for the 1:24,000 scale photography. All scans were saved in TIFF format for the purposes of orthorectification and photointerpretation. Georeferencing/Mosaicking of the TIFFs was performed using a variety of softcopy photogrammetric software including Socet Set Version4.2.1, Autometric Softplotter, PCI OrthoEngine, and Erdas OrthoBASE. First, lens correction parameters were applied to each frame to eliminate image distortion. Airborne kinematic GPS was then used, to provide first order georegistration. Image to image tie-points were then used to further co-register the imagery, especially for photos taken over open water when ground control points were not available. Fixed ground features visible in the scanned photos were selected for ground control points (GCPs)which were then used to georeference imagery. GCPs were measured using a Differentially-corrected Global Positioning System (DGPS). We obtained points with a wide distribution throughout the imagery, especially on peninsulas and outer islands whenever possible since this results in the most accurate registration throughout each image. Only ground control points for terrestrial features were collected due to the difficulty of obtaining precise positions for submerged features. Pre-existing USGS 10-meter digital elevation models were used to correct for relief displacement
(describe or provide URL of description):
6. Data Documentation
The EDMC Data Documentation Procedural Directive requires that NOAA data be well documented, specifies the use of ISO 19115 and related standards for documentation of new data, and provides links to resources and tools for metadata creation and validation.
- 1.7. Data collection method(s)
- 4.1. Have resources for management of these data been identified?
- 4.2. Approximate percentage of the budget for these data devoted to data management
- 5.2. Quality control procedures employed
- 7.1. Do these data comply with the Data Access directive?
- 7.1.1. If data are not available or has limitations, has a Waiver been filed?
- 7.1.2. If there are limitations to data access, describe how data are protected
- 7.2. Name of organization of facility providing data access
- 7.2.1. If data hosting service is needed, please indicate
- 7.4. Approximate delay between data collection and dissemination
- 8.1. Actual or planned long-term data archive location
- 8.3. Approximate delay between data collection and submission to an archive facility
- 8.4. How will the data be protected from accidental or malicious modification or deletion prior to receipt by the archive?
(describe or provide URL of description):
7. Data Access
NAO 212-15 states that access to environmental data may only be restricted when distribution is explicitly limited by law, regulation, policy (such as those applicable to personally identifiable information or protected critical infrastructure information or proprietary trade information) or by security requirements. The EDMC Data Access Procedural Directive contains specific guidance, recommends the use of open-standard, interoperable, non-proprietary web services, provides information about resources and tools to enable data access, and includes a Waiver to be submitted to justify any approach other than full, unrestricted public access.
Notes: The name of the Organization of the most recent Support Role of type "Distributor" is used. The support role must be in effect. This information is not required if an approved access waiver exists for this data.
Notes: This field is required if a Distributor has not been specified.
Notes: All URLs listed in the Distribution Info section will be included. This field is required if applicable.
Project information is available online or on CD-ROM through the NCCOS Biogeography Program.;
Notes: This field is required if applicable.
8. Data Preservation and Protection
The NOAA Procedure for Scientific Records Appraisal and Archive Approval describes how to identify, appraise and decide what scientific records are to be preserved in a NOAA archive.
(Specify NCEI-MD, NCEI-CO, NCEI-NC, NCEI-MS, World Data Center (WDC) facility, Other, To Be Determined, Unable to Archive, or No Archiving Intended)
Notes: This field is required if archive location is World Data Center or Other.
Notes: This field is required if archive location is To Be Determined, Unable to Archive, or No Archiving Intended.
Notes: Physical Location Organization, City and State are required, or a Location Description is required.
Discuss data back-up, disaster recovery/contingency planning, and off-site data storage relevant to the data collection
9. Additional Line Office or Staff Office Questions
Line and Staff Offices may extend this template by inserting additional questions in this section.