2012 OLC Lidar: West Metro, Oregon

WSI has collected Light Detection and Ranging (LiDAR) data of the Oregon West Metro Study Area for the Oregon Department of Geology and Mineral Industries (DOGAMI). The Oregon LiDAR Consortium's West Metro project area encompasses approximately 100,000 acres in Washington, Multnomah, and Clackamas County, Oregon. The study area includes the Beaverton, Hillsboro, and Forest Grove metro areas. Data were delivered in: Oregon State Plane North; horizontal and vertical datum: NAD83 (2011)/NAVD88 (Geoid12a); units: International Feet.

Between December 28th, 2012 and January 4th, 2013, WSI employed remote-sensing lasers in order to obtain a total area flown of 99,684 acres of which 96,543 acres comprise the area of interest. Settings for LiDAR data capture produced an average resolution of at least eight pulses per square meter.

In addition to LiDAR survey, OLC West Metro included high resolution aerial photography was acquired for the entire study area.

Lidar point clouds were projected back to geographic coordinates and ellipsoid heights for storage in the Digital Coast Data Access Viewer.

Original contact information:

Contact Name: Jacob Edwards

Contact Org: DOGAMI

Phone: 971-673-1557

Email: jacob.edwards@oregon.gov

Provide high resolution terrain elevation data.

10577

A final report for this project may be viewed at:

https://noaa-nos-coastal-lidar-pds.s3.amazonaws.com/laz/geoid18/8382/supplemental/OLC_WEST_METRO_DELIVERY_REPORTcompressed.pdf

The delivery acceptance report may be viewed at:

https://noaa-nos-coastal-lidar-pds.s3.amazonaws.com/laz/geoid18/8382/supplemental/West_Metro_2012_LIDAR_QC_Report.pdf

Any conclusions drawn from the analysis of this information are not the responsibility of the Oregon Lidar Consortium, Oregon Department of Geology and Mineral Industries (DOGAMI), the Office for Coastal Management or its partners.

This data can be obtained on-line at the following URL: https://coast.noaa.gov/dataviewer

;

None

Users should be aware that temporal changes may have occurred since this data set was collected and some parts of this data may no

longer represent actual surface conditions. Users should not use this data for critical applications without a full awareness of its

limitations.

unknown

A total of 1,776 measured GCP's were obtained in the Delivery region and compared with the lidar elevation grids. The data delivered to DOGAMI was found to have a mean vertical offset of -0.033 meters (-0.107 feet) and an RMSE value of 0.051 meters (0.166 ft). Offset values ranged from -0.210 to 0.153 meters

For more information about the vertical accuracy, please refer to the final report, listed above in the Supplemental_Information field

of this metadata record.

; Quantitative Value: 0.051 meters, Test that produced the value: Tested RMSE in meters in open terrain

LiDAR data has been collected and processed for all areas within the project study area.

Upon receipt from vendor (WSI), all LiDAR data was independently reviewed by staff from the Oregon Department of Geology and Mineral Industries (DOGAMI) to ensure project specifications were met. All data were inventoried for completeness and data were checked for quality, which included examining LiDAR data for errors associated with internal data consistency, model quality, and accuracy.